New Features

Easier Setup
No user calibration, EVER. Just install and turn power ON.

Universal
Works with Non-Unitril MFDC inverter and 1 Phase AC controls. Change two plug-in relays for use with 125VAC or 24VDC solenoid valve voltage.

Always Ready to Protect
Does not have to be calibrated even when you power-up, change material or change tooling.

Instantly Tunes to Your Welder
Does not stop production to recalibrate. Automatically compensates for changes in transformer tap switch position of line voltage shifts.

New Look
Easy-to-Read Operation Display. Shows exactly what is happening. Can be mounted on either side of the enclosure.

Supports SOFT TOUCH RETRACT
Just add optional RETRACT pneumatic system with HEAD DOWN limit switch for full protection.

Full Electrical Redundancy
All inputs and outputs require a closure of both electro-mechanical and solid-state redundant components for full safe operation. Self-monitors output relay to prevent any operation if a fault is detected.

As Always, The UNITROLSOFT TOUCH

Cannot Be Bypassed.

Sensor Wires Always Clear of Production Area
Sensor wires are connected at the output of welder secondary. Never needs a sensor wire location to be moved closer to the electrodes for any type of welder.

Fast Release
Electrodes close under low force and release in less than half a second if a metal is not detected between electrodes.

Electrodes Close Without Initial Delay
Electrodes start to move at the same time the welding control is initiated. Closing speed is independent of welding pressure.

Works with Ram Depth Limit Switch
For the redundant system requiring both Electrodes Continuity and Ram Depth Limit Switch closure.

Click Here to view the Unitrol Soft Touch Selection Chart

Click Here to view the Unitrol Soft Touch Technical Manual

Pinch Point Safety

Soft Touch System - MFDC (INVERTER)

Soft Touch System - 1ØAC